|
Clean' Brite
Concentrated Floor Cleaner and Brightener
No Rinsing Required
Lemon Scented
IDEAL FOR ALL FLOORS: Terrazzo - Tile - Marble - Magnesite - Cement - Masonry - Vinyl Tile - Exposed Aggregate - Marble Crete - Brick - and Today's no wax Floors
Excellent for large area and small floor maintenance
Clean' Brite is excellent for high speed floor care; use 6 oz per gallon of cold tap water, damp mop and allow Clean' Brite to air dry, then high speed burnish to a dramatic brighter "wet look" finish.
Clean' Brite is excellent for use in commercial automatic floor scrubbing machines.
Clean' Brite contains a special blend of several non-ionic surfactant cleaners which can NOT leave a film on the floor. Optical brighteners, Fragrance and stabilizers are also contained to ensure freshness and gloss, Contains no Phosphorus.
Crystal Seal Penetrating Sealer
Crystal Clear, Colorless, non yellowing
Use on white or other cements
Outdoor or indoor
Dries in 30 minutes
Acrylic Base
Penetrates thoroughly
No Lap marks
No buffing needed
Easy to apply by brush, dip or spray
Crystal Cote
Crystal Clear and Colorless
Use on white or other cements
Outdoor or indoor
Dries in 60 minutes
Acrylic Base
No Lap marks
No buffing needed
Easy to apply by brush, dip or spray
Key Acrylic Sealer
Clear acrylic solution formulated to create a clear, non yellowing protective coating
Provides a tough, UV and abrasion resistant film that effectively protects surfaces from moisture penetration, staining, dirt, dust and wear
Provides a surface that is easy to clean and maintain
Interior or exterior application
Key Acrylic Sealer is most commonly used as a sealer for Epoxy Terrazzo and Polymeric Terrazzo flooring systems. It is used for sealing old and new concrete floors, exterior ramps, decks, sidewalks, slate and exposed aggregate surfaces.
UV Resistant
Excellent Clarity and Color Retention
Low Maintenance Finish
Excellent Abrasion and Mar Resistance
Seals Substrate from Moisture Penetration
*Do not apply below 50 degrees F
*Contains solvent - Keep from ignition sources
*Must be applied with proper ventilation
|
